projects

Shuriken - SX635 AntecMod - Total Conversion

Author: Dennis Garcia

Published: Tuesday, April 16, 2002

Side Fan Cutting

The next step is to remove the fans and mark the grill location on the side panel. I used a fine tipped marker to trace around each of the grills and a triangle to line up the screw holes.

Once again using the Dremel tool I cut spaces for the laser-cut grills to fit in. When finished both grills where pressure fit into place and flushed up to the outer case panel.

Subscribe RSS Feed

Tweet
PlusOne

Table of Contents

Introduction
92mm Fan Enhancement
Side Fan Layout
Side Fan Cutting
Side Fan Fiberglass
Shuriken Window Cutting
Trial Fit
Fan Alignment Fix
Apply Paint
Tinted Window Install
Conclusion

Discuss in the Forums